![]() The wires on the motorcycle turn signals have to be routed thorough rubber grommet and then should follow the route where the old motorcycle turn signals were located. Now that the old motorcycle turn signals are out, it is time to place the new one. Step 7 – Inserting the New M otorcycle Turn Signals Take the screw off and use a wrench to slide the motorcycle turn signals out of the vehicle. Step 6 – Removing the BoltĪfter locating the bolt, you will have to remove it. ![]() The bolt is usually held in place by screws and washers. The next step in replacing the motorcycle turn signals is to locate the bolt that holds it in position. If the motorcycle turn signals are connected by box connection then all you have to do is to clip off the male and female ends. Step 4 – Disconnecting the WiringĪfter taking note of the wiring, the next step is to disconnect the wiring of the motorcycle turn signals. But if they are not then it would be advisable to stick distinct tapes on them so that reconnecting the motorcycle turn signals will not be a problem. Generally the wires are color coded, and disconnecting them is not a hassle. In this case, you will have to take off the tail piece. The wiring for the motorcycle turn signals at the rear is generally located below the seat. The wiring for the motorcycle turn signals have to be located at the front as well as the rear. Removing the fairing will help you access the wires of the motorcycle turn signals at the front. The first step in replacing the motorcycle turn signals is to dismantle the lower fairing to avoid any damages.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |